Fin Plug Repair Estrada - 949-294-4741 DingDrX Surfboard Repair - HYENAS video free download

Jason McQuade

Great repair vid! What was the clear material you stuck over the plug and cut out the shape? Rice paper?

Nicholas Hodgkinson

Dude the song playing to this video is insane haha perfect choreography

Mahalia Hensler

Great video, do you put any material in the plug hole in the board before setting it in? Thanks in advance!

BeachBumOZ1

GERAT VIDEO.......

DingDrx

Hahaha! Give it a try, the worst that can happen is u have to take it to a shop. Just remember, not all shops are the same. Either way i hope it all works out, thanx for watching

lindz151074

So I probably should take it to a shop

DingDrx

Exactly, even though i can see im a bit late with my response. Hope it worked out. If u have any cloth exposure u can clear coat it with some rustoleum satin clear after your 220 sanding. Use about three coats then finish wetvsanding and the weave will dissapear. Check out my dingdrx face book page and like it too. Ill be giving more tips on there as well. Good luck, thanx for watchin

canadasb1

thanks for getting back to me, appreciate it. I'm doing the laminate repair tomorrow.. what exactly is hot coating? Is it just applying another layer of resin? thanks!

DingDrx

You can simply cut it out with a razor blade but its a lot harder to make it look clean. Just take your time with it

canadasb1

Thanks for the upload. Very helpful. Can you please let me know of another way of opening up the plug openings? could i just cut it out?

Chris Hartnett

for the filler what did you use

Wade Hickok

dude, this is awesome

DingDrx

that is modeling clay though you can use anything sandible. thanks for checkin n. dont forget to subscribe for more tips and tricks...

DingDrx

stoooked, dont forget to subscribe. more to come...

istoutgrill

what type of putty do you use for the resin dam? seems like a good idea - i usually just use tape

Zint Masaga

nice video man! learned so much from you.

DingDrx

hey spicy that would be resin. we will be posting the step by step instructions soon...